Auto Control of three phase Induction motor (AT89C51)
Basic Level Skills: Not specified Wed Jun 06 2007, 06:57 pm 
This Project can be used with the three phase Induction motors. The circuit will take the full control of the motor and it will protect the motor from several faults such us over voltage and under voltage and the circuit will switch on the motor under safety conditions. The circuit was fully controlled by the microcontroller and the microcontroller will continuously monitors the voltages of the three phase and if the voltage goes abnormal then it will switch off the motor until they are normal. All the conditions are displayed it over the LCD display. In our project we are using the popular 8 bit microcontroller AT89S52. It is a 40 pin microcontroller.
- Author
- Binu
- Author email
- [email protected]
- Author website
- www.binu.somee.com
Description
This Project can be used with the three phase Induction motors. The circuit will take the full control of the motor and it will protect the motor from several faults such us over voltage and under voltage and the circuit will switch on the motor under safety conditions. The circuit was fully controlled by the microcontroller and the microcontroller will continuously monitors the voltages of the three phase and if the voltage goes abnormal then it will switch off the motor until they are normal. All the conditions are displayed it over the LCD display. In our project we are using the popular 8 bit microcontroller AT89S52. It is a 40 pin microcontroller.
Filesize
41.12 kB
Downloads
36983
Rating
- << Previous [Digital Clock with Alarm Using DS1307 and 8051 (updated)]
- Back to list
- [Automatic College Bell (AT89S8252 & DS1307)] Next >>
Comments
ztaletpzca
Wed Apr 24 2024, 11:19 pm
IrardlPex
Wed Apr 24 2024, 08:42 pm
Charlestehed
Wed Apr 24 2024, 05:20 pm
Robertgurse
Wed Apr 24 2024, 02:43 pm
Richardedils
Wed Apr 24 2024, 04:07 am
Malcolmaccek
Wed Apr 24 2024, 01:21 am
ChrisLub
Tue Apr 23 2024, 05:21 pm
Davidbab
Tue Apr 23 2024, 10:41 am
I am looking out to develop a 3 phase electronic motor soft starter. Basically the motor must be applied with less voltage at the beginning and ramp up to the maximum voltage(415vac) with in 6 seconds.
Pl guide me how to proceed