SIM 300 GSM Module
Thu Apr 09 2009, 11:02 am
also...
SIM card takes some time to register... for that i had used delay of 15 sec in my program.. so is der any direct command for checking the SIM card registration???
SIM card takes some time to register... for that i had used delay of 15 sec in my program.. so is der any direct command for checking the SIM card registration???
Sat Apr 11 2009, 02:44 pm
yes there is command for sim registration to network.
AT+CREG?
response is
+CREG: 0,1 //registered to home network
+CREG: 0,2 //searching for network
+CREG: 0,5 //registered to network in roaming
AT+CREG?
response is
+CREG: 0,1 //registered to home network
+CREG: 0,2 //searching for network
+CREG: 0,5 //registered to network in roaming
Tue Apr 14 2009, 04:19 pm
we are going to read one register from ADE7754 IC and that value we need to send to GSM Module to get that data through sms on mobile..... how should i proceed??? could u plz reply..
Wed Apr 15 2009, 02:28 am
first finish reading that register, later i will tell you how to send it not to worry..
Wed Apr 15 2009, 11:12 am
Hi,
First try with AT+CMGS="your Phone no." then enter
then you will find > symbol then put your message and then Ctrl-z.
message will be transmitted
First try with AT+CMGS="your Phone no." then enter
then you will find > symbol then put your message and then Ctrl-z.
message will be transmitted
Wed Apr 15 2009, 03:52 pm
We have send the message through microcontroller also.. i m asking somethng else...we are reading one register from ADE7754 IC and that value we need to send to GSM Module to get that data through sms on mobile..... plzz help..
Thu Apr 16 2009, 10:00 am
Hi,
whatever value you get from ade7754, first try to make it readable,like try to send it to UART and see if it is readable at hyperterminal,In short you will have to convert the received value from register to ASCII first then you can send it as message.
whatever value you get from ade7754, first try to make it readable,like try to send it to UART and see if it is readable at hyperterminal,In short you will have to convert the received value from register to ASCII first then you can send it as message.
Powered by e107 Forum System