pic programmer circuit

welcome here praveepraba88
as its ur first post

hello sir,
i want to make a devlopment board for pic 16f8xx for learning purpose. so that's why i wnt to program my pic on dev board(In ckt). so i want to made ICSP ckt. i hv build a icsp ckt given in below link:
http://www.olimex.com/dev/images/pic-pg1-sch.gif
i hv directaly use ICSP six pin .see attachment of my pcb ckt.
the problem is that
**when i m using winpic800 the led on programmer board blinking with each operation like "erase device","read", but when programm warning---programming failed,and device detected unknown.
**when i m using PICPgm there is also led blinkikg wd each operation but warning "NO PIC Connected"
when i m using IC_PROG there is no hdware detecte(there is no led blinking) of prog board
what is proble plz help , is there is problem in my prog ckt or ,which programmer work fine wd it.i hv conecte ICSP 6 pin like
6-pgm -36 of pic
5-clok -39
4-data -40
3-gnd -12 &31
2-vdd -11 &32
1-mclr/vpp -1, is there is need of supporting ckt in pic controller side.
i hv made a JMD programmer of majoka sir ( of which this icsp ckt is part ) working fine wd WINPIC800.i m busy wd this progmer ckt for 2-3 days.
i hv complited all port of my development board,i hv to add only ICSP in my board .
plz i need yr kind suport, plz

hi yashshailesh
once check ur connections again
as it is simple circuit and it should run
i make it also but with zif socket

hello sir,
thanks sir. Sir hv u seen my ckt. which programmer software hv u used.

hi yashshailesh
yes i see ur word file
do one thing
download pic 16f877 data sheet
and see its pin no on which data and clock has to go
match that with ur circuit u make
may be there is a swap between clock and data
i use PICPgm

i very interested with this project.this programmer can use for pic 16f?and other?and when i open mplab what should programmer should i use?like pickit2

hi Mamat

this programmer can use for pic 16f?and other?

yes it is for pic 16 f and 18f
Pic Pgm,winpic800,win pic, IC_Prog can be used with this hardware
using with mplab u need pickit2 programmer it also support some other MPLAB ICD2 etc

use winPICPGM for programing.......!!!!!!!!

welcome alishaheen,
yas!, it is working with winPICPGM and also with winpic800.