Strange problem with 8051uc 16x2 lcd in 4bit mode.
Discussion in "Project Doubts" started by pratikshinde Jul 19, 2012.
Thu Mar 21 2013, 03:19 pm
Delays are mentioned here:
http://www.8051projects.net/lcd-interfacing/lcd-4-bit.php
Startup delay 20ms, then 10ms, then 1, 1, 1ms. I think your delays are not calibrated.. try to use timer for delays. create a 1ms delay loop and pass ms variable from top.
http://www.8051projects.net/lcd-interfacing/lcd-4-bit.php
Startup delay 20ms, then 10ms, then 1, 1, 1ms. I think your delays are not calibrated.. try to use timer for delays. create a 1ms delay loop and pass ms variable from top.
Fri Mar 22 2013, 10:37 am
hi Ajay
I have connected LED to pin P0^0 but LED was not blinking with 1s delay it was just blinking
I have connected LED to pin P0^0 but LED was not blinking with 1s delay it was just blinking
Fri Mar 22 2013, 01:00 pm
just give proper delay values it should work fine. Proteus is a simulator it cannot simulate hardware delays sometimes. It only check for proper commands in case of LCD.
Powered by e107 Forum System