Sensors

In my actuator status, in the 1st line it must display "C: *** PU:***" where *** is either "ON" or "OFF". Initially it was working perfectlybut after making a few modifications in my code for other purposes (and no change made in the display part) it is diaplaying some junk instead of "C:". Everytime i reset, it changes. Its either "GC" or yen symbol etc... What has gone wrong?

Hey sorted out that problem
I had made a collosal blunder. Realised it when i tried debugging the code and used the logic analyser feature..

I had put 3 instructions ie >10bytes after org 00h and that was overlapping with the isr for INT0.

So i made the necessary change and it is working perfectly!!

Amit Radha

hello amit

i was just looking :-| 2 ur previous posts n found dis on page 25. itz the same prob i hv now, coz i m also following d same codes of u. me also noticed these b4, bt i dnt know whr 2 change in the codes in order to solve it out...
i hope u get me... pls help me out.