about the Protues software some Problem!

dear friend,
when i try the run the program i found out have some problem for the Physical Partlist view!pls refer the photo.but the program still can running ,this problem will effect me to make the PCB design!!pls let me know how to setting back the missing package !thank you!!

You will only have the problem while using the ARES tool. u can continue simulation using the ISIS without any issues.

If ARES is what u need. then u will be prompted abt the missing components. u need to choose a package which is near to it.

Suppose u simulate a RED Animated LED, the component will be missing in ARES, u simply choose the LED as the package and it works.

ARES needs the exact pinout and pin distances for exactness so u can chose the nearest posible package.

Correct me if i am wrong

yup!you right still can continue simulation using the ISIS without any issues.

can you let me know how to choose the package which is near to it for my component(capacitor)?

yup!you also right the component will be missing in ARES,that will effect to build the circuit !!

can you let me know how to do!!

I never used ARES for layout but as I know, I think you can select package once you import the netlist to ARES.

but the connection will make me to confuse..do you have any idea for this way???

caps are always of standard size... either if its SMD or through hole type. you should not have any problems.

what you meaning??

I was talking about PCB footprint for ARES. I missed your question maybe

can you let me know how to set the package for the capacitor?

any ppl can answer my question?