Buzzer Interfacing with P89V51RD2
Discussion in "8051 Discussion Forum" started by prajwalsnh Oct 17, 2013.
Thu Oct 17 2013, 07:26 pm
Thu Oct 17 2013, 10:41 pm
I actually ran into a problem similar to this while working on my current project. Make sure that there's enough current going into the base, otherwise you will not switch the transistor. Play around with the values of a the resistances.
Fri Oct 18 2013, 01:22 pm
try to remove that pull down resistor on the port pin side and see if that works. I agree with Raiden, base current is always an issue and you need to play with different values.
Fri Oct 18 2013, 02:58 pm
I got the Output It worked with 10K resistor without any problem. Actually the problem was with PIN. I changed the PIN and it s working absolutely fine Thanks Raiden and Ajay Sir
Powered by e107 Forum System