Servo motor anglewise rotation depending on serial data from 8051..

hello..,
i m doing my project but i stuck on angle-wise motion of servo motor actually servo rotating fully 90 degree to 180 degree completely but i want to rotates it angle wise depending upon the serial data from 8051 micro-controller.so please help me..!

How are you controlling your servo right now? You need to post your schematic and code so we can help you better.

[Topic moved to 8051 Discussion Forum]

we are going to take data (angle) by serially to micro-controller and depending on that data servo motor should rotate at desired position.

that is fine.. I understand the concept of what you're trying to do. But how you're doing it? I need to see if you are doing it right? I want to see the source code.