Eclipse-sdcc with C language
Discussion in "8051 Discussion Forum" started by salemalqahtani Jul 20, 2014.
Sun Jul 20 2014, 10:33 am
Hi All,
I am new for micro controller programming and I installed eclipse and sdcc. Everything were good but when I executed the program something went bad. There is a message appearing on my screen after hitting execution button " sh.exe has stopped working" what is it please and how can I get ride of it.
Sincerely
I am new for micro controller programming and I installed eclipse and sdcc. Everything were good but when I executed the program something went bad. There is a message appearing on my screen after hitting execution button " sh.exe has stopped working" what is it please and how can I get ride of it.
Sincerely
Mon Jul 21 2014, 10:47 am
Its hard to say what went wrong. What was the last action you did before this broke? Did you change any file? or Did you mistakenly uninstalled something? Have you tried reinstalling it?
Tue Jul 22 2014, 01:45 am
but when I executed the program something went bad. There is a message appearing on my screen after hitting execution button " sh.exe has stopped working"salemalqahtani
Which program were you executing ,Eclipse or a program you have written ?
Are you running Windows ?
If Eclipse will not run try uninstalling and trying again.
Tue Jul 22 2014, 11:47 am
This type of problem comes in gcc based softwares. I found similar discussion topic here:
http://embdev.net/topic/228200
Maybe it helps.
http://embdev.net/topic/228200
Maybe it helps.
Powered by e107 Forum System