compin and gsm interface
Discussion in "Project Help" started by rodrider Aug 9, 2014.
Sat Aug 09 2014, 02:57 am
friends i have attached the code and proteus simulation but cannot communicate with controller in proteus, gsm and hyperteminal works fine please and advice thanks
Sat Aug 09 2014, 09:02 pm
Remove virtual terminal from your schematic coz you cannot connect two TX together. If you want to monitor data from both then better use two virtual terminals and connect only rx of both VTs to uart lines.
And did you do COMPIM settings properly? can you post screenshot of compim settings?
And did you do COMPIM settings properly? can you post screenshot of compim settings?
Powered by e107 Forum System