LED dotmatrix is unable to display any character
Discussion in "Project Doubts" started by vipinpathakg May 27, 2015.
Wed May 27 2015, 11:58 am
I have created all the hardware of 5x7 LED Dotmatrix ( without UDN 2981 , IC not available in local market) as per the instructions given in "Dotmatrix Updated Design Project". Then programmed the AT89S52 using a programmer (purchased from market). Atter connecting to power supply LED displays only moving blocks.
Please tell me how to send character on LED display.
Please tell me how to send character on LED display.
Wed May 27 2015, 07:47 pm
UDN2981 is required to drive the LED matrix, are you using any alternative? You can send display data from serial port. But by default you should be able to see something.
vipinpathakg like this.
Powered by e107 Forum System