Discussion in "Project Doubts" started by    Ritesh    Aug 31, 2006.
Thu Aug 31 2006, 12:39 pm
#1
hi,
i am currently desingning a PCB of home automation ove internate
i noticed that the output of 89c51 (i.e. 1 to 8) is directly given ..
but i think there should be pull up resistors bank of 10 k to make stability...while operating relay's with driver transistors..
what u think?
and also..
can we also check the status of the condition ..like ON or OFF status of machine

thanking you
Riteh Jain
Thu Aug 31 2006, 05:21 pm
#2
well if we are connecting the Relays then Driver transistors are required. i have just designed the circuit for cheaper cost using LED just to give idea and every LED denotes a device or switch, and main this to show is switching over internet. so i didnt put much stress on the appliance section.
yes we can check the status also.
i have made a command named "stat" for checking the status.
it will tell u the appliances are on/off and will show u the recent 3 messages sent to the LCD.
Mon Sep 04 2006, 02:59 am
#3
u can use bc547 transistor there and connect relay or mosfet at output so i hope this will help u

Mon Sep 04 2006, 03:01 am
#4
values r 560 ohms,47k,4k7,1k.

Get Social

Information

Powered by e107 Forum System

Downloads

Comments

Bobbyerilar
Thu Mar 28 2024, 08:08 am
pb58
Thu Mar 28 2024, 05:54 am
Clarazkafup
Thu Mar 28 2024, 02:24 am
Walterkic
Thu Mar 28 2024, 01:19 am
Davidusawn
Wed Mar 27 2024, 08:30 pm
Richardsop
Tue Mar 26 2024, 10:33 pm
Stevencog
Tue Mar 26 2024, 04:26 pm
Bernardwarge
Tue Mar 26 2024, 11:15 am