question on Proteus
Sat Dec 11 2010, 12:05 am
Hi,
Again, I am new to Proteus. I try to use analogue analysis and don't know why no graph shows. Please check my setting of the analysis. I can't change the axis setting.
thanks.
Again, I am new to Proteus. I try to use analogue analysis and don't know why no graph shows. Please check my setting of the analysis. I can't change the axis setting.
thanks.
Sat Dec 11 2010, 10:32 am
hi harrison
in your SET Y AXIS SCALING dialogue box you can see LOCK VALUES check box. just click tat. then u can change the axis values
in your SET Y AXIS SCALING dialogue box you can see LOCK VALUES check box. just click tat. then u can change the axis values
Sat Dec 11 2010, 01:57 pm
hi Harrison
in case of problem with Proteus
u can refer to Proteus samples in c drive that installed when Proteus installed
also help section of Proteus is useful thing
in case of problem with Proteus
u can refer to Proteus samples in c drive that installed when Proteus installed
also help section of Proteus is useful thing
Sun Dec 12 2010, 12:28 am
Sun Dec 12 2010, 07:01 pm
hi Harrison
i think ur going to change the sample of Proteus that's why ur getting grey the check box
start with new design the u can edit the properties
i think ur going to change the sample of Proteus that's why ur getting grey the check box
start with new design the u can edit the properties
Mon Dec 13 2010, 09:02 pm
hi Harrison
make ur own schematic
do not change the Proteus sample
as it has limitations in editing
make ur own schematic
do not change the Proteus sample
as it has limitations in editing
Mon Dec 13 2010, 09:49 pm
Hi,
the reason I just put ??? is that I have nothing to say. Of course, I tried to make my own circuit and graph before I post the forum. I don't know why you can do and I am not able to do. I still think there is setting different. I spend times and still don't find why.
thanks.
the reason I just put ??? is that I have nothing to say. Of course, I tried to make my own circuit and graph before I post the forum. I don't know why you can do and I am not able to do. I still think there is setting different. I spend times and still don't find why.
thanks.
Mon Dec 13 2010, 11:10 pm
hi Harrison
don't worry its ue learning
see this video u will understand all
http://www.youtube.com/watch?v=ctTtTdBZFqc
if still problem tell
i provide u a Proteus sample
simulation of graph is different from simulation of Proteus if Proteus is stop u can start a graph
right click on graph then u will see a option simulate graph click on that u will see a graph
don't worry its ue learning
see this video u will understand all
http://www.youtube.com/watch?v=ctTtTdBZFqc
if still problem tell
i provide u a Proteus sample
simulation of graph is different from simulation of Proteus if Proteus is stop u can start a graph
right click on graph then u will see a option simulate graph click on that u will see a graph
[ Edited Mon Dec 13 2010, 11:34 pm ]
Harrison like this.
Powered by e107 Forum System