PIC16F877 - Siemens C55 - max232 - rs232 SMS Sending
Wed May 25 2011, 11:50 pm
Thu May 26 2011, 12:37 am
@ galapacos
first check is serial communication is doing or not
short pin 3 and 4 on the schematic that is data in and data out and send any character u should see it back
first check is serial communication is doing or not
short pin 3 and 4 on the schematic that is data in and data out and send any character u should see it back
[ Edited Thu May 26 2011, 12:38 am ]
Thu May 26 2011, 12:55 am
im sending data from microcontroller, if i do short 3 and 4 how can i send any character??? thx
Thu May 26 2011, 12:56 am
im going crazy, if i couldn't do this project i will not graduate , really i need help too much...
Thu May 26 2011, 01:16 am
im sending data from microcontroller, if i do short 3 and 4 how can i send any character??? thxgalapacos
If you connect pins 3 and 4 (Max232 9+10) it will loop anything sent to the MAX232 back to the sender.
This tests a lot of the circuit.
Connect to a PC, using the attached program or similar.
Can you post your Proteus project and source code.
[ Edited Thu May 26 2011, 02:02 am ]
Thu May 26 2011, 01:43 am
it is laser security system wtih sms sendng when laser cut logic 1, red led burning and sms will send. i save the pdu message to siemens c55 s memory and im sending to mobile AT+CMSS=1. It means send 1. message in mobiles's memory it is working on proteus COMPIM. i connect to mobile to my laptop and it sends SMS but on breadboard it doesnt :S
Thu May 26 2011, 01:47 am
In the circuit in your first post the power is taken from CTS and RTS.
Your microcontroller does not connect these pins.
To test,remove the 78L05 regulator and supply the 5 volts from the microcontroller board.
Your microcontroller does not connect these pins.
To test,remove the 78L05 regulator and supply the 5 volts from the microcontroller board.
[ Edited Thu May 26 2011, 01:56 am ]
Thu May 26 2011, 01:57 am
ooh ok sorry.
http://www.dosyaupload.net/6769705.html
and this is the code:
http://www.dosyaupload.net/861996.html
http://www.dosyaupload.net/6769705.html
and this is the code:
http://www.dosyaupload.net/861996.html
Thu May 26 2011, 02:30 am
before i did it first without 78l05 i used only tx,rx and gnd pins of rs232 and it doesnt work. i thought it is about mobile's working voltage 0-3,3v and did first picture which i share again result is same
Powered by e107 Forum System