is there any code for moving message for atmega 16 rather than 8051 please send to my mail if POSSIBLE

1 want 5*7 dot led matrix moving programing by 8051 witth codein asm, thanks.

@samarnath dev, check LED Dot Matrix Display Tutorial Package. It has sample codes for controlling basic displays displays.

Please i tried running the design on proteus, but displaying the message was impossible, Please how do i use d virtual terminal on proteus for test?

@Mstein, Virtual terminal is provided in the Proteus. Please post in forum if you need detailed help. I cannot post the complete solution in comments area.

Could you please help me how to change the display text in the proteus simulation file. It displays "This is just the beginnng". how to change it?

@gsdvprasad, post your question in forum.

So I tried it out, and it works fine. The sample code shows on a 4*6 format, but with a little adjustment, I got it on 5*7 display perfectly. I also incorporated a source driver in place of d PNP transistors, and it gave a very bright display, since I used leds to build my matrix. The matrix was 80*7 and it works fine. Thank you guys..you got a wonderful forum here..

@mstein, Can you please share back your design with us? It may be helpful for other? Please send me details on contact[at]rickeyworld[dot]info

Could you please help me how to change the display text in the proteus simulation file. It displays "This is just the beginning". how to change it?

@Padam Modi, It must be in the code somewhere. Post in forum for help.

How can I get this circuit diagram & PCB layout image for making moving display

sir please i have problem uploading massage to my s.m.m, if i upload message with your terminal it will nt respond, i dnt no how u connect your 24C16,i connected my @,2,3,4,7 to negative(gnd) 6,5 to sck,sda, and8 to positive(+5v) please help me out i have checked serial cable and pc pot dey are ok please solution should sent to my mail

@martinsnc115877
If you post your problem in the forum we may be able to help.
Search through old posts, someone else may have had the same problem.

Sir plz anyone help me I need water flow meter coding in Kiel vision in assembly language...

Log in and post in the 8051 forum, asking for help.
Give full details of your project.

Sir
I need ur help urgently.i am trying to make pc controlled led scrolling display using 8051.when i am trying to generate hex file of the code that is given by pratik suthar.it gives the error
Target not created
Limit:0800h
I am using keil uvision4 software.

Even i have tried to burn the given hex file that is atteched with the code but my led are not glowing.
Pls help me sir .i struck in this problem from last month and till now i am not able to short out the problem.
Pls suggest me to solve the problem.mail me at [email protected]
Thanks