Digital Alarm Clock using DS 1307
Discussion in "Project Doubts" started by SIRAJ Nov 8, 2006.
Wed Nov 08 2006, 10:35 pm
Hello Ajay
I made the above project of alarm clock but on LCD only 'day' and slashes of date,alarm icon was shown rest all was black and the switches were not working.
our project was submitted and it was a failure. (
we were very upset ao please tell what was wrong in that. (
I made the above project of alarm clock but on LCD only 'day' and slashes of date,alarm icon was shown rest all was black and the switches were not working.
our project was submitted and it was a failure. (
we were very upset ao please tell what was wrong in that. (
Thu Nov 09 2006, 05:11 am
Well the project is fine and working.. there has been an update in the project from the last release. i hope you have downloaded the new one.
There was a small change in the schematic of the project. please download the latest update file from the download section.
visit here: http://www.rickeyworld.info/download.php?view.3
check the connection according to the new schematic.. everything is same just a small connection at the switches side. please see the pdf file in the new archive for more help.
There was a small change in the schematic of the project. please download the latest update file from the download section.
visit here: http://www.rickeyworld.info/download.php?view.3
check the connection according to the new schematic.. everything is same just a small connection at the switches side. please see the pdf file in the new archive for more help.
[ Edited Thu Nov 09 2006, 05:18 am ]
Thu Nov 09 2006, 05:15 am
please take a look at this...
that is the small change.. please update ur circuit and try again!
that is the small change.. please update ur circuit and try again!
Thu Nov 09 2006, 02:51 pm
here is one more screenshot of working clock.. made by a guy from Persia.
hope that will satisfy you.
hope that will satisfy you.
Sat Nov 11 2006, 01:00 am
thanks for this but its too late now to make any change coz the project is submitted with failure. u should have made it clear before, ne ways thanks
Sat Nov 11 2006, 03:05 pm
well Siraj, you should have checked it and then submit it.. i donno how u just made and submit without even checking that your board is working or not.. you should make things clear first.
anyway.. i am not saying its your mistake but.. be careful when doing a project.
anyway.. i am not saying its your mistake but.. be careful when doing a project.
Tue Nov 14 2006, 05:57 pm
well i did checked the project with the ckt diagram.
I had cross checked it with the ckt diagram older one
I didnt had the updated one so i couldnt do anything
well its ok now neways Thanks
I had cross checked it with the ckt diagram older one
I didnt had the updated one so i couldnt do anything
well its ok now neways Thanks
Powered by e107 Forum System