Home automation small changes
Discussion in "Project Addition or Changes" started by Sath007 Nov 17, 2010.
Wed Nov 17 2010, 12:19 pm
Hi Ajay Sir,
I have problem troubleshooting the given codes of home automation using keil compiler to prove to my lect its working. Moreover the microcontroller u use is at89c51 and the microcontroller i used is at89s51. Can i use the same hex code u giv 4 my project.
I have problem troubleshooting the given codes of home automation using keil compiler to prove to my lect its working. Moreover the microcontroller u use is at89c51 and the microcontroller i used is at89s51. Can i use the same hex code u giv 4 my project.
Wed Nov 17 2010, 06:20 pm
where are you facing problem?
code is specifically written for HAserver software so you might be facing problem coz of that. Let me know precisely what problems are you facing?
code is specifically written for HAserver software so you might be facing problem coz of that. Let me know precisely what problems are you facing?
Wed Nov 17 2010, 08:14 pm
you cannot compile just a single file. what are you trying to do exactly?
Wed Nov 17 2010, 08:19 pm
Normally wen we finish writing code we need 2 compile and check the output rite. Therefore hw 2 make the cmd.c codes 2 run on telnet.
Wed Nov 17 2010, 08:34 pm
you are using two threads for a single problem. Stick to one thread. either this or that. ok? lets not mess up the forum keep it clean.
Powered by e107 Forum System