interfacing GLCD with AVR
Discussion in "AVR Discussion Forum" started by abbas1707 Jan 8, 2008.
Tue Jan 08 2008, 12:09 am
hi people!!! :-)
i want to do something on graphical lcd (t6963 based) using AVR. i worked with ks0108 using 8051 in past but that was not good experience..i had to use external memory to store bmp images.
please guide me!! i dont know how to use t6963 based glcd,how to create fonts .etc...
Hope u people can suggest me what to do or where to find helping material.
Thanx in advance :-|
i want to do something on graphical lcd (t6963 based) using AVR. i worked with ks0108 using 8051 in past but that was not good experience..i had to use external memory to store bmp images.
please guide me!! i dont know how to use t6963 based glcd,how to create fonts .etc...
Hope u people can suggest me what to do or where to find helping material.
Thanx in advance :-|
Tue Jan 08 2008, 01:16 am
Hi,
check the attached, I don't know how to use avr, but I'm pretty sure the code is for AVR,
it even comes with lcd simulator.
I found it in a German forum, via google search.
Don't forget to share your results
good luck!
check the attached, I don't know how to use avr, but I'm pretty sure the code is for AVR,
it even comes with lcd simulator.
I found it in a German forum, via google search.
Don't forget to share your results
good luck!
Mon Jan 14 2008, 01:14 pm
hi,
i was interfacing ks0108 lcd wid AVR but facing some problem..i wrote program to display an image but only 4 pages( 0 to 3) are correctly displayed on lcd , after that again data is overwritten on first 4 pages instead of going on pages 4 to 7.this is the same program i used with 8051.on 8051 it works fine but not on AVR.
please help me finding mistake
i was interfacing ks0108 lcd wid AVR but facing some problem..i wrote program to display an image but only 4 pages( 0 to 3) are correctly displayed on lcd , after that again data is overwritten on first 4 pages instead of going on pages 4 to 7.this is the same program i used with 8051.on 8051 it works fine but not on AVR.
please help me finding mistake
Mon Jan 14 2008, 10:46 pm
Looks everything normal to me.. just try.. not to return from main..
put a while(1); loop there.. will take a closer look later if you can explain the code a little bit.. highlighting the problem..
put a while(1); loop there.. will take a closer look later if you can explain the code a little bit.. highlighting the problem..
Powered by e107 Forum System