assembler
Mon Feb 04 2008, 01:25 am
i check there.i see the adc program! but i dont know where should i put in my program. pleaze say it.and is my shematic is right?
Mon Feb 04 2008, 10:32 pm
shabnam
i have corrected your code, there were little mistakes,
i have added adc part from tutorial section
also there was a mistake in proteus file.....u were using an adc which dont have simulation model...
check the files
ask if any problem
i have corrected your code, there were little mistakes,
i have added adc part from tutorial section
also there was a mistake in proteus file.....u were using an adc which dont have simulation model...
check the files
ask if any problem
Powered by e107 Forum System