Discussion in "Project Help" started by    abbas1707    Mar 5, 2007.
Mon Mar 05 2007, 10:52 pm
#1
hi
i want 2 interface a dc motor with 8051 but i need circuit description..should i have 2 use uln2803???? or something else! plzzzz help me!
Tue Mar 06 2007, 08:37 pm
#2
no the interface is really simple. Make use of L293D refer to the datasheet, for more help. Its the best motor driver for dc motors as well as stepper motors. Its of very simple interface.
Tue Mar 06 2007, 10:04 pm
#3
no need to use uln2803, make use of L293D H bridge motor driver. Not costly, and very simple interface. It is used not only to drive dc motors but also stepper motors also. So you can use it, interfacing it with controller is very simple. See datasheet formore more details.

Get Social

Information

Powered by e107 Forum System

Downloads

Comments

MnoioCoove
Tue May 21 2024, 02:06 am
PedroDug
Sun May 19 2024, 05:39 pm
JewelAmuck
Sun May 19 2024, 03:06 pm
Minniemus
Sun May 19 2024, 07:39 am
Andyhet
Sat May 18 2024, 07:28 am
BrettTibre
Fri May 17 2024, 06:14 pm
Gordonfax
Fri May 17 2024, 10:28 am
Davidspils
Fri May 17 2024, 10:19 am