EVM
Discussion in "Project Doubts" started by gigyani Apr 23, 2019.
Tue Apr 23 2019, 09:22 PM
How to enter the electronic voting machine into voting mode?
I have tried a lot but its not going to voting mode, it enters directly into result mode in which each candidate take equal amount of votes.
i have attached a photo of the project as it starts.
without this its doing nothing, so what could be the appropriate error?
I have tried a lot but its not going to voting mode, it enters directly into result mode in which each candidate take equal amount of votes.
i have attached a photo of the project as it starts.
without this its doing nothing, so what could be the appropriate error?
[ Edited Tue Apr 23 2019, 09:23 PM ]
Wed Apr 24 2019, 12:29 AM
http://www.8051projects.net/download-d205-electronic-voting-machine-managed-control-unit-project-report-included.html
At the end of the post the author adds a note about running cufirst.hex file in your controller.
Have you done that ?
At the end of the post the author adds a note about running cufirst.hex file in your controller.
Have you done that ?
Thu Apr 25 2019, 01:17 AM
when i add cufirst.hex its not working.
after 2-3 sec i add voting.hex again it goes to resulst mode
after 2-3 sec i add voting.hex again it goes to resulst mode
Powered by e107 Forum System