News Item: The 89S52 Project Board with ISP loader
(Category: 8051 Projects)
Posted by coolmirza143
Fri May 06 2011, 09:34 am
Here is a simple way to make you own Development Board, this board uses ISP Loader easy to program.
![]()
This board is also having a thermistor sensor, you can see temperature value Display
![]()
Board consist Tact Switch, Debug LED, Voltage Regulator (LM2940-5) you can use 7805 too for this job, on board 12 bit ADC and Header for LCD. Tiny bard that can be made in very short time.
The ISP loader cable can be built easily using DB25 connector and 6-pin SIP socket. The wire length should be less than 50 cm. The hardware is compatible with Asim's ISP software.
![]()
[Source]
[Submitted by coolmirza143]
This news item is from Rickey's World of Microcontrollers & Microprocessors
( http://www.8051projects.net/news.php?extend.167 )
(Category: 8051 Projects)
Posted by coolmirza143
Fri May 06 2011, 09:34 am
Here is a simple way to make you own Development Board, this board uses ISP Loader easy to program.
This board is also having a thermistor sensor, you can see temperature value Display
Block diagram of the 89S52 Project Board
Board consist Tact Switch, Debug LED, Voltage Regulator (LM2940-5) you can use 7805 too for this job, on board 12 bit ADC and Header for LCD. Tiny bard that can be made in very short time.
The ISP loader cable can be built easily using DB25 connector and 6-pin SIP socket. The wire length should be less than 50 cm. The hardware is compatible with Asim's ISP software.
[Source]
[Submitted by coolmirza143]
This news item is from Rickey's World of Microcontrollers & Microprocessors
( http://www.8051projects.net/news.php?extend.167 )