RFID on leeky
Discussion in "Project Help" started by ericlee Jan 11, 2008.
Fri Jan 11 2008, 09:25 am
hi
i am trying on leeky(em4095 RFID reader v2.0) project.
the problem i face is i cant read the tag...when i connect it to the hyperterminal.it only show em4095 RFID reader v2.0. when i attach the tag..no signal is captured..the tag i use is em4100..
i try to measure the signal waveform on 2 point of the antenna..one end i get is sinewave and the others end is square wave...Y?? i thought both should be square wave? the squarewave i get is approximate 125khz..
so anyone can help me out?
thanks....
i am trying on leeky(em4095 RFID reader v2.0) project.
the problem i face is i cant read the tag...when i connect it to the hyperterminal.it only show em4095 RFID reader v2.0. when i attach the tag..no signal is captured..the tag i use is em4100..
i try to measure the signal waveform on 2 point of the antenna..one end i get is sinewave and the others end is square wave...Y?? i thought both should be square wave? the squarewave i get is approximate 125khz..
so anyone can help me out?
thanks....
Sat Jan 12 2008, 01:31 am
hi thl...
sorry cud not oen up the schematic...
1.just let me know if the ready pin has been pulled down...
please try pulling down the ready pin by a 100k resistor...
2.in your code.. idont think "em4095 RFID reader v2.0" has any relevance... hope u using only for debugging purpose??
sorry cud not oen up the schematic...
1.just let me know if the ready pin has been pulled down...
please try pulling down the ready pin by a 100k resistor...
2.in your code.. idont think "em4095 RFID reader v2.0" has any relevance... hope u using only for debugging purpose??
Powered by e107 Forum System