the new kid!
Discussion in "Welcome Forum" started by stevo Aug 17, 2008.
Sun Aug 17 2008, 06:26 pm
Hey there! I am new to this and need some help!
I need to display angular shaft position and shaft diameter deviation on a PC?
Do I need a microcontroller?
If any one can assist me I would be real happy!
Thanx
stevo
I need to display angular shaft position and shaft diameter deviation on a PC?
Do I need a microcontroller?
If any one can assist me I would be real happy!
Thanx
stevo
Mon Aug 18 2008, 12:05 am
locking the thread...
duplicate post!
duplicate post!
[ Edited Mon Aug 18 2008, 12:07 am ]
Mon Aug 18 2008, 02:56 am
welcome stevo to forum, please continue in other thread where you have posted your problem 
. Enjoy your stay..
. Enjoy your stay..
Powered by e107 Forum System
FrabSeby
Thu May 16 2024, 07:31 pm
PeterGem
Thu May 16 2024, 06:27 am
Timothywalay
Thu May 16 2024, 04:40 am
Timothypet
Wed May 15 2024, 06:14 pm
RandyBence
Wed May 15 2024, 02:00 pm
JordanDic
Wed May 15 2024, 01:55 pm
DavidDeelf
Wed May 15 2024, 11:16 am
ytaletjkca
Wed May 15 2024, 09:45 am