Microcontroller 8051 with PC interface
Thu Dec 16 2010, 03:50 pm
what ru sending from pc
ru check the led code
first check that please
if that is ok then come to serial port
check all boxes as hex binary and decimal
ru check the led code
first check that please
if that is ok then come to serial port
check all boxes as hex binary and decimal
[ Edited Thu Dec 16 2010, 03:54 pm ]
Thu Dec 16 2010, 04:00 pm
yes led workd correctly
now em backd to serial port
here now im sending 4rm microcontroller n it iz showing dez thng instead of ABCDEFG......
now em backd to serial port
here now im sending 4rm microcontroller n it iz showing dez thng instead of ABCDEFG......
Thu Dec 16 2010, 05:04 pm
awl thng wrkng properly now jst change of output cum wat could be da error ??
Fri Dec 17 2010, 01:26 am
hi Maherbaloch
go a simple experiment
i think it may be a problem of max 232
take out controller from its base
short 10 and 11 pin by wire controller should not be in ic base
send any character from pc u should receive that in the same format
it will verify is max is ok or not
go a simple experiment
i think it may be a problem of max 232
take out controller from its base
short 10 and 11 pin by wire controller should not be in ic base
send any character from pc u should receive that in the same format
it will verify is max is ok or not
Fri Dec 17 2010, 01:38 am
do the above experiment it will verify ur max 232 portion and its wiring
if it is verified then it is easy to detect where is problem
do above experiment short pin 10 and 11 without controller and send data from pc u should receive same
if it is verified then it is easy to detect where is problem
do above experiment short pin 10 and 11 without controller and send data from pc u should receive same
Fri Dec 17 2010, 01:41 am
okay i will do dat 2mrrow coz i dnt hv serial port available on my computer
Powered by e107 Forum System