Discussion in "Project Help" started by    Yemmi    Nov 7, 2007.
Wed Nov 07 2007, 02:47 pm
#1
hello..i'm new here..but now i need ur help guys...
for my project..i'm using AT89C2051 as the controller...in this project i need to run the motor by transferring data using RF...for the remote,i use PC(Visual basic)...
here..i want to learn how to make a program for running motor...and maybe have any suggestion from u all guys...
Wed Nov 07 2007, 05:14 pm
#2
which type of motors?? can u explain a little bit
Wed Nov 07 2007, 08:35 pm
#3
check the tutorial section.. you will get tutorial for both DC motor as well as stepper motor... which one you are using?
Thu Nov 08 2007, 04:17 am
#4
i'm using dc motor(12v)...
Thu Nov 08 2007, 09:27 am
#5
so go through the DC motor tutorial

Get Social

Information

Powered by e107 Forum System

Downloads

Comments

Dulcehet
Fri May 10 2024, 04:22 pm
RonaldNak
Thu May 09 2024, 07:45 pm
Jamescon
Thu May 09 2024, 12:52 pm
RobertSkats
Thu May 09 2024, 10:23 am
hvCar
Thu May 09 2024, 05:53 am
DJGlido
Wed May 08 2024, 09:28 pm
migCar
Wed May 08 2024, 04:48 pm
TimmyJup
Wed May 08 2024, 12:22 am