Help needed for "Android controlled Robot using bluetooth"

Sir,
We are doing the project "Android controlled Robot using bluetooth" downloaded from your site.
The main PCB is done and we need some solutions for the completion.
I have some doubts regarding it.
1.What is CONN SIL6? Is it just a 6pin connector?
2.Do we need to solder the bluetooth with resistors ,capacitors and LEDs according to HC-05 schematic provided?
3.We are freshers in working with Bluetooth. So, please provide the basic steps to configure it.
Please reply as soon as possible.
Many Thanks in advance.

Need help a bit faster..
Thanks in advance..

Have you read the thread just before this one entitled
"[Urgent] Help needed for making Android Controlled robot"
?

Yes, CONN SIL6 Is just a 6pin connector.

Check this for reference: Urgent Help Needed for Bluetooth Controlled Robot

Sir,
We are doing the project "Android controlled Robot using bluetooth" downloaded from your site.
The main PCB is done and we need some solutions for the completion.
I have some doubts regarding it.
1.What is CONN SIL6? Is it just a 6pin connector?
2.Do we need to solder the bluetooth with resistors ,capacitors and LEDs according to HC-05 schematic provided?
3.We are freshers in working with Bluetooth. So, please provide the basic steps to configure it.
Please reply as soon as possible.
Many Thanks in advance.

venkyrsv

2. Can you please specify the HC-05 module you bought, if it is HC-05 with ttl base then you don't need to connect anything.

3. By default bluetooth module works in slave mode at 9600bps, so you don't not need to configure the module for this project.


You can follow my thread [Urgent] Help needed for making "Android Controlled robot". for reference.